Stalker Pole Mounted Message Display Board and Radar Speed Sign (PMMD), Traffic Control, includes Bluetooth, includes 3 preconfigured messages: SLOW DOWN, SCHOOL ZONE, and SPEED LIMIT, optional Traffic Data Analyst

Your Estimated Lead Time Is 3-4 Weeks
Free Shipping
Your Estimated Lead Time Is 3-4 Weeks
Free Shipping

Stalker Pole Mounted Message Display (PMMD), Calm traffic, proactively address Complaints, Collect Valuable Data

Control Traffic

Emphasize your department’s safety commitment with this effective traffic calming tool in response to civilian complaints or in locations where a speed reminder is adequate to slow down motorists.

Combining a 2- or 2½-digit radar speed display and two 6-character lines give the PMMD a presence hard to ignore.

It’s water-resistant and operates in temperatures from ± -20° to 120° F (-29° to 48° C). The Stalker PMMD can be placed in virtually any location and perform reliably in any weather.

  • Get motorists attention
  • Respond to civil complaints
  • Easy position and set up

Deliver the message

The PMMD’s message sign allows the display of static messages with high brightness LEDs. The sign’s message is programmable and set using the Stalker PMD Wizard App, or remote control interface on the speed sign. Each message consists of two lines, each with 6 characters. The sign comes preconfigured with three messages:


A configurable timer controls which message is displayed and when it’s displayed. The sign’s light intensity adjusts to ambient light conditions.

Get a real picture of traffic with the Stalker Traffic Analyst

    • Collect valuable data for Grant requests
    • Demonstrate proactive enforcement in problem areas

Activate the Stalker Traffic Analyst and deploy a PMMD in a problem area. Get a real picture of traffic conditions and collect traffic data supporting your next Grant request.

The statistics option allows the Pole Mounted Display to collect traffic statistics while providing speed information to drivers. It can also be run with the sign off.

Internal timers allow for targeting of
critical timeframes for more exact data and results.
Almost unlimited data can be collected.

The data is stored in a removable USB thumb drive hidden inside the locked access door at the bottom of the sign. 

Easy Setup with the Stalker PMD Wizard App

The PMMD is capable of pairing with a tablet or computer for easy programming.

Using Stalker’s PMD Wizard, all timers, alerts, speeds, messages, and optional statistics can be set from within an intuitive, user-friendly interface. Complicated programming for up to a full year can be accomplished from within the Wizard.

The wireless function only requires that the tablet or computer be paired with the sign and be using the Stalker PMD Wizard user interface. Alternatively, the included infrared remote control can also configure the PMD. It is conveniently stowed in the underside of the sign in a locked access compartment.

Either the wireless device or remote control can fully configure and control the PMMD. Parameters available are:

  • Internal clock time and date
  • Speed limits for speed alert display
  • Type of alert display
  • Internal timers for:Maximum and minimum speeds to display
    • When to show speeds
    • When to use speed limit to use for
      speed alert
    • When to collect statistics
      (if option is installed)
  • Up to 5 messages that can be displayed 

Locking Access Door

The speed display’s remote control and removable flash drive are conveniently stored inside the unit. No more searching for the remote control. It stays with the PMMD.

Secure Mounting

A rugged, 2-piece mounting bracket is standard on all PMMD units. The bracket makes for easy installation and gives added security for maximum equipment retention.

5 Independent Timers

The PMMD supports five independent timers which configure the sign to perform particular functions only during times selected. The timers are controlled by an internal real time clock that allows each timer’s start and stop time to be set on any date and at any time.

  • Up to 5 operational time segments
  • Up to 4 different flash alerts
  • User programmable messages

The timed functions are:

  • Show vehicle speeds
  • Show over-speed alerts
  • Collect traffic statistics (requires Statistics option)
  • Show messages 

Display Range Up to 99 (199 option)
Display Units mph or km/h
Character Size Speed Sign: 15 inches (38 cm)
Message Sign: 5" x 3"
Display Color Amber on black background
Character Type Speed Sign: 7-segment, 32 high-intensity LEDs per segment
Message Sign: 16 segment, 4-8 high-intensity LEDs per segment
Intensity Adapts to ambient light conditions
Speed Alert Flashing
Speed Hold Time 2-second standard, configurable

Radar Performance

Speed Range 1 – 200 mph (321.9 km/h)
Speed Resolution 1 mph (1 km/h)
Distance Range 1000 feet (304.8 m)
Speed Accuracy ±0.5 mph ±0.3%
±0.8 km/h ±0.3%
Configuration Fully configurable with dedicated RS-232 port.
Size: 11.2 cm x 9.9 cm x 4 cm (4.4” x 3.9” x 1.6”)
Environmental: Operate -4°F to +140°F (-20°C to +60°C)
Storage -40°F to 185°F (-40°C to +85°C)
Transmit power (EIRP): 19 dBi (79 mW)
Antenna Gain: 15 dBi
Transmit Frequency: 24.125 GHz
Transmit bandwidth 100 MHz
Transmit Type: Continuous wave
Beam Width: Horizontal 32°
Vertical 30°


Input Options 110 or 220 AC (50/60 Hz)
Power Usage 7 watts standby
24 watts typical display
36 watts Peak


Size 26” x 36.5” x 2.3”
(66 cm x 92.7 cm x 6 cm)
Housing Material Aluminum
Weight 40 lbs. (18 kg)
Suggested Mounting Height Minimum of 7 feet (2.13 meters) to bottom of sign


Operating Temperature -22° to 120° F (-30° to 49° C)
Vented weather resistant housing


Related Products

Customers Also Viewed